Table of Contents
Advertisement
MEDIA CONTROL
(cont. from previous page)
1
Peel-Off Mode
2
Continuous Mode
TOF Detect Fault
Ticket Save Mode
TOF Adjust Mode
TOF Adjust
MEDIA CONTROL Submenus
Print Intensity
This option specifies the level of thermal energy from the printhead to be used
for the type of media and ribbon installed.
Large numbers imply more heat (thermal energy) to be applied for each dot.
This has a significant effect on print quality. The print intensity and speed
must match the media and ribbon type to obtain the best possible print quality
and barcode grades.
The range is -15 through +15.
The factory default is -3.
Fast*
Standard
Standard*
Tear-Off
3 Labels*
9 Labels
Disable*
Enable
Disable*
Enable
3
0.00 to 0.40 Inches
Notes:
* = Factory Default
Italicized items are available only when Admin User is set to Enable (in
the PRINTER CONTROL menu).
1
The Peel-Off option under Media Handling must be enabled for this
menu to function.
2
The Continuous option under Media Handling must be enabled for
this menu to function.
3
In increments of 0.01 inch.
MEDIA CONTROL Submenus
Tear Strip Full
1 Label
127
Advertisement
Table of Contents
