Table of Contents
Advertisement
Chapter
3
PRINTER CONTROL
Glob Mem Adjust
This menu allows you to adjust the ratio of global memory allocated to label
size versus PGL forms, fonts, and logos. For example, when using short
labels, you can allocate more memory to forms, fonts, and logos by increasing
the Glob Mem Adjust value.
The amount of installed DRAM is 32 (MB). The range is 0 - 12160 KBytes and
the default is 9120 KBytes.
Max Font Buffer
The maximum amount of DRAM allocated for downloading fonts (True-Type,
Scalable, or Bit Map).
The range is 100 to 800 Kbytes, and the factory default is 100 Kbytes.
Max Cache Memory
The Maximum Cache Memory option specifies the size of the memory block
that can be allocated to the font cache. The font cache stores bitmaps that are
created on demand from the font outlines stored on the printer flash. The
cache allows the printer to print scalable fonts at optimum speed.
To calculate the memory requirement, use this equation:
horizontal
resolution x
The allowable range is 50 KBytes through 900 KBytes in 50-KByte
increments.
The factory default is 900 KB.
NOTE: For most applications, the default settings for font memory are
160
average
character
vertical
height
resolution x
(inches) x
acceptable. Therefore, do not change the defaults unless your
application requires an uncommon memory configuration.
average
character
# of characters
width
to be cached
(inches) x
8
Advertisement
Table of Contents
