IBM Infoprint 6700 Series User Manual page 216

Chapter 3
Emulation Submenus
Early Print Cmpl (Coax, TN3270)
(From page 167, page 179.) Early Print Complete capability allows the printer
to send print (order) complete status to the host before the printer is actually
done printing all data. This option is valid only when the printer is in DSC/DSE
mode.
•
Disable. The printer will suppress the Early Print Complete response until
all printing is complete.
•
Enable. The printer will send an acknowledgement to the host when it is
able to accept more data.
NOTE: When an Early Print Complete is enabled and an error occurs, there
The factory default is Disable.
Early Print Comp (IPDS)
(From page 175.) This parameter allows you to choose when to send a Print
Complete to the Controller.
•
Off. Print Complete is sent if the page is printed completely.
•
On. Print Complete is sent immediately. The next page will be created.
This improves the print performance when starting the next page, but
degrades error recovery.
The factory default is Off.
Elong./Alt. Font
(From page 194.) Controls which host command sets elongated (double high)
fonts and extended character set.
•
ELNG=BS (hex 08) FONT=SO (hex 0E)
•
ELNG=SO
The factory default is Elng=BS Font=SO.
Emulation
(From page 175.) This item allows you to select the desired IPDS emulation,
either 4028 IPDS or 3816 IPDS.
The factory default is 4028 IPDS.
Epson Set
(From page 199.) This item allows you to select the Epson character subset
used by the printer. The options are listed on page 207.
The factory default is ASCII (USA).
216
may be data loss.
FONT=BS