IBM Infoprint 6700 Series User Manual page 228

Chapter 3
Emulation Submenus
IGP100 Compatibl.
(From page 185.) This parameter forces the output to correspond with
IGP-100 printer output in cases where there are differences.
The options are Disable (the factory default) and Enable.
Intervention Req
(From page 167, page 173, page 179.)
•
Send To Host. The printer sends a signal to the host computer when a
printer fault or hold mode time-out occurs.
NOTE: If you select Send To Host, make sure the Error Recover option
•
Do Not Send. No signal will be sent to the host computer.
The factory default is Send To Host.
Italic Print
(From page 190, page 193, page 195, page 197, page 199.)
•
Disable. Text is printed normally.
•
Forward Slant. Text is printed with a forward slant.
•
Backward Slant. Text is printed with a backward slant.
The factory default is Disable.
LAC Approx.
(From page 170.) This item controls whether or not the LAC Approximation is
used. (See the Coax/Twinax Programmer's Reference Manual .)
When set to On, then Approximation is used. When set to Off, Approximation
is not used, and incoming data will print as is. The factory default is On.
LAC Option
(From page 170.) Allows the host system to load alternate character images
into the printer. This may be used for designing graphics, bar codes, and
charts, or for printing in foreign languages.
•
Enable. Prints the LAC character as defined.
•
Disable. Ignores the LAC definition from the host and prints from the
currently selected character set.
The factory default is Enable.
228
(under MEDIA CONTROL) is set to Disable. If Error Recover is not
set to Disable, Intervention Req will not work properly.