Chapter
3
BATTERY CONTROL
BATTERY CONTROL
BATTERY
1
CONTROL
Battery Monitor
2
Time To Go
2
Percent Charge
2
Current Draw
2
Voltage
2
Amp-Hour Used
+/- xx.x Amp-Hours
2
Time To Go Alert
2
High Volt Alert
2
Low Volt Alert
BATTERY CONTROL Submenus
Battery Monitor
•
Disable (the default). When set to Disable, the other Battery Control
menus do not display. The Serial Port is restored to normal use, and the
Serial Port menu displays.
•
Enable. When set to Enable, the other Battery Control menus display.
The Serial Port is reserved for monitoring the power cart, and the Serial
Port menu does not display.
When Battery Monitoring has been enabled and the printer is online, the
second line of the LCD message displays the time remaining as "Batt
xxx.xx Hrs."
The factory default is Disable.
288
Disable*
Enable
3
xxx.xx Hours
3
xxx.x %
3
+/- xx.xx Amps
3
xx.xx Volts
3
1.0 Hours*
.3 - 12.0 Hours
16.0 Volts*
12.5 - 16.0 Volts
9.5 Volts*
8.5 - 11.5 Volts
Notes:
* = Factory Default
1
Does not appear if the CTHI option is installed.
2
Available only when you select "Enable" in the Battery Monitor
submenu (in the BATTERY CONTROL menu).
3
You cannot change this value; it is a display only item.