Toshiba 650CT Maintenance Manual page 2

Parallel port
®
This port can be used to connect a Centronics compatible printer or other parallel
device. The port supports an Extended Capabilities Port (ECP) conforming to
IEEE·1284.
Serial port
The serial controller is 16550UART compatible. This standard, 9-pin, serial port can
be used to connect serial devices such as a serial printer, serial mouse, or external
modem.
External monitor port
The female, 15-pin, D-shell connector can be connected to an external SVGA moni-
tor. This computer supports Video Electronics Standards Association (VESA) Display
Data Channel (DDC) 2B compatible functions.
™
PS/2 mouse/keyboard port
Either a PS/2 compatible keyboard or a PS/2 compatible mouse can be connected to
this port.
PC card slot
The PC card slot can accommodate two PCMCIA Release 2.01 Type II (5.0mm)
cards or one Type III (10.5mm) card. These slots are ready for advanced cards, includ-
ing PC card 16's multifunction cards and CardBus 32-bit cards, as well as the Zoomed
Video (ZV) port, which is dedicated to high-performance video data transfer such as
MPEG video play back.
Docking Adapter port
This 240-pin port enables connection of an Enhanced Port Replicator II or a Desk
Station V Plus to the computer through a Docking Adapter.
The Enhanced Port Replicator II duplicates the following ports on the computer: PS/2
keyboard, PS/2 mouse, serial port, parallel port, external monitor, audio line-in,
headphone and microphone. It also provides an audio line-out joystick port and two
additional PC (Type III) card slots.
The Desk Station V Plus provides additional features to Enhanced Port Replicator II's
as follows: two PCI/ISA bus and one PCI bus expansion slots, a 5.25-inch drive bay,
a Selectable Bay, and an on-board SCSI-2 (Small Computer System Interface) con-
troller.
External FDD port
Allows you to connect an external FDD.
1-2
650CT