4.20 Interface Connector Board
Removing the Interface Connector Board
To remove the interface connector board, follow the steps below and refer to Figures 4-48 to
4-50.
1.
Remove the Docking Adapter covers as described in Section 4.19.
2.
Remove four M2.5x6 screws securing the interface connector assembly and lift
off the assembly.
Figure 4-48 Removing the interface connector assembly
3.
Remove three M2.5x4 screws, two M2.5x6 screws and two bolt screws
securing the interface connector board to a metal plate.
Figure 4-49 Removing the interface connector board and cover
650CT
4-49