Toshiba 650CT Maintenance Manual page 169

6. Remove the microphone's rubber cover.
Figure 4-44 Removing the microphone's rubber cover
7. Peel back the tape securing the microphone cable so you can remove the cable.
8. Pull the microphone cable out from the gap between the display cover and top
cover, then remove the microphone.
Installing the Microphone
To install the microphone, follow the steps below and refer to Figures 4-44 and 4-43.
1. Thread the microphone cable between the display cover and top cover.
2. Secure the microphone cable with tape and position the core so that one end is
aligned with a notch in the top cover. There should be a little slack in the cables.
3. Replace the microphone's rubber cover.
4. Seat the microphone in its case. The microphone cable should fit into a slot on
the case.
5. Secure the microphone cable cover. Be sure the latches lock into place.
6. Secure the ground cable with one 2.5x6 screw.
7. Install the LCD module, FL inverter board, display mask, top cover and display
assembly, keyboard, DAA, HDD, and battery pack as described in Sections 4.16,
4.15, 4.14, 4.8, 4.7, 4.6, 4.5, and 4.2.
650CT
4-45