4.
Remove two hexagonal-head screws securing the connector cover to the
interface connector board.
Installing the Interface Connector Board
To install the interface connector board, follow the steps below and refer to Figure 4-50 back
through 4-48.
1.
Secure the connector cover to the interface connector board with two
hexagonal screws.
2.
Secure the metal plate to the interface connector board with three M2.5x4
screws, two M2.5x6 screws, and two bolt screws.
3.
Secure the interface connector assembly to the Docking Adapter with four
M2.5x6 screws.
4.
Install the Docking Adapter covers as described in Section 4.19.
4-50
Figure 4-50 Removing the connector cover
650CT