Toshiba 650CT Maintenance Manual page 176

4. Remove the two retaining rings on each side of the connecting mechanism, then
remove the washers (note their position), and then the connector mechanism
locking pins.
5. Turn the connecting mechanism over and remove two M2.5x4 screws from each
side.
6. Separate the connecting mechanism, eject devices and covers.
Figure 4-53 Removing the screws, eject devices and covers
Installing the Connector Mechanism
To install the connector mechanism, follow the steps below and refer to figures 4-51 to 4-53.
1. Assemble the covers, eject devices and connecting mechanism.
2. Turn the connecting mechanism upside down and secure two M2.5x4 screws, one
on each side.
3. Install the two retaining rings, washers and locking pins on each side of the
connecting mechanism.
4. Seat the connecting mechanism and lever and secure the lever with one M3x4
screw.
5. Replace the springs on both sides of the Docking Adapter and position the guide
rails (right and left).
6. Replace the covers as described in Section 4.19.
4-52
650CT