Table of Contents
Advertisement
5.
If desired, use the Toshiba Case Separator tool to release the 17 latches along the
edges of the display mask. Begin at the top (four latches), continue along the
sides (four latches on each side), and then the bottom (five latches).
Installing the Display Mask
To install the display mask, follow the steps below and refer to Figures 4-35 and 4-34.
1.
Set the display mask in place and connect the 17 latches. Begin at the bottom
(five latches, continue along the sides (four latches on each side), and then the top
(four latches).
2.
Secure the display mask with two M2.5x6 screws.
NOTE: Support the display with your hand, a book, or support block when
you insert the screws.
3.
Replace two screw masks covering the screws.
4.
Install the battery pack as described in Section 4.2.
650CT
Figure 4-35 Releasing the latches
4-35
Advertisement
Table of Contents
Troubleshooting
