Toshiba 650CT Maintenance Manual page 121

(d)
650CT
When you select one of the above options, except for Not used, a
subwindow similar to the one below appears to let you set the parallel
port mode. The options for this setting are ECP (default) and Std. Bi-
Direct.
Mode
DMA
For most printers, the port should be set to ECP. With some other
parallel devices, the setting should be Std. Bi-Direct.
Sound system
This item allows you to enable or disable the sound system.
Enabled Enables the sound system. (Default).
Disabled Disables the sound sysem.
When Enabled is selected, a subwindow similar to the one below
appears to let you set the WSS I/O address, SBPro I/O address,
Synthesizer I/O address, WSS & SBPro IRQ Level, WSS & SBPro
DMA, Control I/O address, MPU401 IRQ Level, and Joystick I/O
address for the sound system.
SOUND SYSTEM
WSS I/O Address
SBPro I/O Address
Synthesizer I/O Address
WSS & SBPro IRQ Level
WSS & SBPro DMA
Playback
Record
Control I/O Address
MPU401 (MIDI I/F) IRQ Level
Joystick I/O Address
WSS I/O address Use this option to set the WSS I/O address from
among the following settings:
534h (default), 608h, E84h, F44h
SBPro I/O address Use this option to set the SBPro I/O
address from among the following settings:
220h (default), 240h
OPTIONS
= ECP
= Channel 3
= 534H
=
= 388H
= IRQ5
= Channel 1
= Channel 0
= 120H
=
= 200H
220H
Not Used
3-67