Table of Contents
Advertisement
Installing the FL
To install the FL, follow the steps below and refer to Figures 4-42 back through 4-38.
1.
Carefully seat the FL.
2.
Seat the FL cover and secure it with the silver tape.
3.
Lay the control board in place and connect the flexible cable. Make sure the flip
up connector is in the up position before connecting the cable.
4.
Secure the control board with two M2x2 silver screws and two M2x2 black
screws.
5.
Secure the FL cable with tape.
6.
Turn the display panel over and secure the four latches.
7.
Install the LCD module, FL inverter board, display mask and battery pack as
described in Sections 4.16, 4.15, 4.14 and 4.2.
650CT
4-43
Advertisement
Table of Contents
Troubleshooting
