Table of Contents
Advertisement
4.16 LCD Module
Removing the LCD Module
To remove the LCD module, follow the steps below and refer to Figure 4-37.
1.
Turn off the power to the computer, then disconnect the AC adapter and all
external cables connected to the computer.
2.
Remove the battery pack, optional memory module, optional PC card, display
mask and FL inverter board as described in sections 4.2, 4.3, 4.4, 4.14 and 4.15.
3.
Remove four M2x6 screws securing the LCD module to the display assembly.
NOTE: Lay the display on a support block when you remove the screws.
4.
Carefully lift out the LCD module enough to access the display cable. Remove
the tape securing the display cable, then disconnect the cable.
4-38
Figure 4-37 Removing the LCD module
650CT
Advertisement
Table of Contents
Troubleshooting
