Table of Contents
Advertisement
4.
Disconnect the display cable from PJ7, then release the membrane pressure
connector from PJ6 on the I/O board.
5.
Remove the tape securing the cables. Disconnect the microphone cable from
PJ502 and the backup battery cable from PJ803 on the system board. Be
careful not to break the cable when removing it. You may need a pair of tweezers
in order to grasp the cable.
6.
Remove one M2x6 screw securing the ground cable.
650CT
Figure 4-20 Disconnecting the cables
Figure 4-21 Removing the ground cable screw
4-21
Advertisement
Table of Contents
Troubleshooting
