3-10
Disassembly and Assembly of the Platen Chassis and Cutter
Chassis
3-10-1
Disassembly and Assembly of Standard Model
The disassembly procedure is explained mainly. When assembling the parts, follow the disassembly
procedure in reverse.
♦
Removing the Sector Gear Plates 1 and 2
1) Remove screws A (1 pc. each), and remove sector gear plate 1 and sector gear plate 2 from the
platen chassis.
♦
Removing the Platen Chassis
1) Remove E rings (2 pcs.), washer A (1 pc.), washers B (3 pcs.), spring L (with spring cap) and
spring R1, and remove the platen chassis from the base frame.
*
Pull the bottom (where the mounting holes are located) of the platen chassis outwards
when removing the platen chassis.
*
In the case of the auto cutter (optional) model, open the cable retainer of the auto cutter
cable upwards and remove the cable.
Auto cutter (optional)
*
With the standard model, a
dummy cutter is attached.
Cutter chassis
Platen chassis
Sector gear plate 1
Screw A
Binding head screw M2 × 4
Spring R1
Washer B
Washer A
E ring (3.0)
Cable holder
*
The above figure shows a standard model.
Screw A
Binding head screw M2 × 4
Mounting hole
Sector gear plate 2
Base frame
Auto cutter cable (optional)
3-26
CD-S500 Series
Spring cap
E ring (4.0)
Washer B
Spring L