Remove The Pressure Roller; Remove The Bottom Cover; Remove The Auto Cutter Acs-241 From The Chassis; Remove The Control Board From The Chassis - Citizen iDP3240 Service Manual

2.2.6 Remove the pressure roller:

(1) Remove the 2 M2.6×6 Screws from
the printer cover.
(2) Bend the roller spring to remove it
from the roller holder.
(3) Bend the roller holder's bearing
section to remove the roller.

2.2.7 Remove the bottom cover:

(1) Remove the 2 M3×8 screws located in the
lower part of the bottom cover.
(2) Lifting the back of the bottom cover, remove it.
2.2.8 Remove the Auto Cutter ACS-241
from the chassis:
(1) Disconnect the connector for the cutter
connected to the control board.
(2) Remove the 2 M2.6×6 screws and lift the
ACS-241 upwards to remove.

2.2.9 Remove the control board from the chassis:

(1) Remove all connecting cables on the board.
(2) Remove the 3 M3×8 screws.
(3) While taking special care not to deform or
damage the paper-near-end sensor and power
switch, etc, lift the chassis straight up.
Roller holder
Pan head screw M2.6 × 6
Roller spring
Printer cover
Screw M2.6 × 6
Bottom cover
Chassis
Screw M3 × 8
7
iDP3240 SERVICE MANUAL
Roller
ACS-241
Control board