Citizen CD-S500 Series Service Manual page 156

<Soft Control-SW>
Command Type
The emulation is selected from EPSON/STAR/CBM1/CBM2.
Initial value: EPSON
Number of Col.
The number of full dots in a full column is 200 dots.
Initial value: 40/33
Number of Col.
40/33
42/35
* By the change of line columns from 40/33 to 42/35 or vice versa, the space between characters
and the mechanical right margin are changed.
Font Select
The initial font size is selected immediately after the power is turned on.
Initial value: 7 × 9
Paper Plies
Copy mode is selected. OFF/2P/3P can be selected. But when 3P is set, the printing speed is low.
Initial value: OFF
Paper End
Sets PE signal at the time of paper end to "enabled" or "disabled". This setting is effective only for
the Centronics interface.
When it is enabled, BUSY, PE, and FAULT are output and printing stops at paper end.
When it is disabled, only BUSY is output and printing stops at paper end.
Initial value: ENB
Paper Near-End
Sets PE signal at the time of paper near end to "enabled" or "disabled". This setting is effective only
for the Centronics interface.
When it is enabled, PE and FAULT are output and printing continues.
When it is disabled, nothing is output and printing continues.
Initial value: ENB
Space between
Font Select
Characters
9 × 9 dots
3 dots
7 × 9 dots
3 dots
9 × 9 dots
2 dots
7 × 9 dots
2 dots
6-12
CD-S500 Series
Printing Line Full Columns (when
Columns including half dot)
33 columns 200 dots (400)
40 columns
35 columns 193 dots (386)
42 columns