Initial Factory Shipping Mode; Cut Position Adjustment Mode - Citizen CD-S500 Series Service Manual

Concerning MechanicalSW Operation
Functions that are not supported by the specifications at time of shipping have no impact on printer
operations even when the settings are changed.
Example: Changes in the auto cutter setting for models that are not equipped with an auto cutter.
Changes in the TakeUp Device setting for models that are not equipped with a rewinder.
6-6-3

Initial Factory Shipping Mode

While POWER, P.OUT, and ERROR LEDs are flashing, reopen and then close the front cover to set
the printer to initial factory shipping mode. When the mode has changed, the three LEDs are lit.
Then, press FEED switch for three seconds or longer to restore the FROM setting to the factory
default. After confirming that FEED switch is released, the printer goes to normal power-on status
through POWER ON RESET operation.
6-6-4

Cut Position Adjustment Mode

While POWER and ERROR LEDs are flashing, reopen and then close the front cover to set the
printer to cut position adjustment mode. When the mode has changed, POWER and ERROR LEDs
are lit.
When the printer enters cut position adjustment mode, it prints the present adjustment values and
stands by for the next key operation.
Operation Method
Pressing FEED switch (for less than 2 seconds):
The adjustment value is changed by ±1/144 inch.
Opening and closing the front cover:
+/− of the adjustment direction is changed.
When the printer enters the adjustment mode, the value changes in + direction. The direction is
changed by opening and closing the front cover.
Pressing FEED switch continuously (for 2 seconds or more):
After the present value is saved to FROM, the printer goes to normal power-on status through
POWER ON RESET operation.
Adjustment range:
−035 to +035
Initial value:
+000
Cut position
Cutter Amendment: +000
6-15
CD-S500 Series