Citizen CD-S500 Series Service Manual page 162

<Ment. Information>
FROM VER. -DP01-0000
FROM DATE -MM.DD.YY
BOOT DATE -MM.DD.YY
BK MARK -
Air Temp. -
Head Temp. -
Head Temp. -
Head1 -XXXXXXXXX Dot
Head2 -XXXXXXXXX Dot
Head3 -XXXXXXXXX Dot
Head4 -XXXXXXXXX Dot
Head5 -XXXXXXXXX Dot
Head6 -XXXXXXXXX Dot
Head7 -XXXXXXXXX Dot
Head8 -XXXXXXXXX Dot
Head9 -XXXXXXXXX Dot
Feed -XXXXXXXXX Stp
Cutter -XXXXXXXXX Cut
Paper Width
Auto-Cutter
Color Ribbon
Take-Up Device
Black Mark
Head Initialize
Feed Initialize
Cut Initialize
Power ON Info.
* The total number of dots and running steps are read out from FROM to RAM when the printer
turns on and renewed at the time of printing or paper feed. When the printer is off, or if no data
is received for 3 minutes or longer, the values are saved in FROM. At the time of saving, if the
status is ONLINE, it becomes OFFLINE during data writing. For the following 6 items, equipped
functions vary depending on customers (factory option).
* The settings are adjusted before delivery at factory according to the required functions. These
settings are saved as the factory default and used as default when user initializes the printer
(returns the setting to the factory default).
(1) Paper Width
(2) Auto-Cutter
(3) Color Ribbon
(4) Take-Up Device
(5) Black Mark
(6) Power ON Info.
Note: If this mode is closed by opening and closing the cover, the setting of the
software switch will be initialized.
FROM version printing
XXXX Crt. Black Mark Adjustment value
XXXX Crt. Adjustment value of the current inside body temperature
XXXX Crt. Adjustment value of the current head temperature
XXXX Max. Maximum detection temperature
Total number of printing dots of 1PIN
Total number of printing dots of 2PIN
Total number of printing dots of 3PIN
Total number of printing dots of 4PIN
Total number of printing dots of 5PIN
Total number of printing dots of 6PIN
Total number of printing dots of 7PIN
Total number of printing dots of 8PIN
Total number of printing dots of 9PIN
Number of running steps (by 24/144 unit)
Number of cutting times
-76.2 76.2/69.5/57.5
-ON OFF/ON
-ON OFF/ON
-ON OFF/ON
-OFF OFF/TOP/ BTM.F/BTM.R (Mark sensor:
-NO NO/YES
-NO
NO/YES
-NO
-NO
NO/YES
NO/YES
6-18
(Cutter: Equipped/Not equipped)
(Color control:
(Rewinder control:
(Reset of the total dot number of head pin:
(Reset of the number of running steps:
(Reset of the number of cutter cutting times:
(Initial response at the time of start-up [3B, 31, 00]
CD-S500 Series
Valid/Invalid)
Valid/Invalid)
Valid/Invalid)
Operated/Not operated)
Operated/Not operated)
Operated/Not operated)
Operated/Not operated)