Hydraulic Unit Operation Tests - Yamaha 2009 Diversion XJ6S Service Manual

6. Fill:
Brake master cylinder reservoir
G
(with the specified amount of the recom-
mended brake fluid)
Recommended fluid
DOT 4
EWA13090
WARNING
Use only the designated brake fluid. Other
G
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
Refill with the same type of brake fluid that
G
is already in the system. Mixing brake flu-
ids may result in a harmful chemical reac-
tion, leading to poor brake performance.
When refilling, be careful that water does
G
not enter the brake fluid reservoir. Water
will significantly lower the boiling point of
the brake fluid and could cause vapor lock.
ECA13540
NOTICE
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean up
any spilt brake fluid immediately.
7. Bleed:
Brake system
G
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" on page 3-14.
8. Check the operation of the hydraulic unit ac-
cording to the brake lever and the brake ped-
al response. (Refer to "HYDRAULIC UNIT
OPERATION TESTS" on page 4-53.)
ECA14770
NOTICE
Always check the operation of the hydraulic
unit according to the brake lever and the
brake pedal response.
9. Delete the fault codes. (Refer to "[D-1] DE-
LETING THE FAULT CODES" on page
ABS (ANTI-LOCK BRAKE SYSTEM)
1
2
8-142.)
10.Perform a trial run. (Refer to "TRIAL RUN" on
page 4-56.)
EAS22800

HYDRAULIC UNIT OPERATION TESTS

The reaction-force pulsating action generated in
the brake lever and brake pedal when the ABS
is activated can be tested when the vehicle is
stopped.
The hydraulic unit operation can be tested using
the following two methods.
Hydraulic unit operation test 1: this test checks
G
the function of the ABS after the system was
disassembled, adjusted, or serviced.
Hydraulic unit operation test 2: this test gener-
G
ates the same reaction-force pulsating action
that is generated in the brake lever and brake
pedal when the ABS is activated.
Hydraulic unit operation test 1
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
1. Place the vehicle on the centerstand.
2. Turn the main switch to "OFF".
3. Remove:
Seat
G
Refer to "GENERAL CHASSIS" on page 4-1.
4. Check:
Battery voltage
G
Lower than 12.8 V → Charge or replace the
battery.
Battery voltage
Higher than 12.8 V
TIP
If the battery voltage is lower than 12.8 V,
G
charge the battery, and then perform hydraulic
unit operation test 1.
If the battery voltage is lower than 10 V, the
G
ABS warning light comes on and the ABS does
not operate.
4-53