Yamaha 2009 Diversion XJ6S Service Manual page 107

1. Right handlebar switch lead
2. Radiator fan motor lead
3. Ignition coil #2, #3 connector
4. Main switch lead 2
5. Main switch lead 1
6. Immobilizer lead
7. Left handlebar switch lead
8. Front wheel sensor lead
9. Connector
10. ABS test coupler
11. Ignition coil #1, #4 connector
12. Throttle cables
13. High tension code
14. Cover
15. Spark plug cap #4
16. Spark plug cap #3
17. Spark plug cap #2
18. Spark plug cap #1
A. There is no order in overlapping the wire harness
in this area.
B. The either positive and negative ignition coil con-
nectors can be connected to the each terminal.
C. To air cut-off valve
D. Clamp the wire harness. Direct the end of clamp
in and downward. No need to cut off its end.
E. Place the right handlebar switch lead coupler and
the radiator fan motor lead coupler underneath of
the air cut-off valve.
F. There is no order in overlapping the high tension
codes.
G. Install spark plug caps #1 to #4 in the directions
as shown.
2-62
CABLE ROUTING