1. Fuel tank breather hose
2. Rectifier/regulator
3. Battery negative lead
4. Starter relay
5. Starter motor lead
6. Battery positive lead
7. Fuel tank drain hose
8. Throttle body joint coupler
A. To crankshaft position sensor
B. To AC magneto
C. To oil level switch
D. To sidestand switch
E. To ground lead
F. To neutral switch
G. Clamp the wire harness.
H. Insert the wire harness into the plate nut.
I. Clamp the wire harness and starter motor lead.
Direct the end of clamp out and downward.
No need to cut off its end.
J. To fuel pump
K. To rear brake light switch
L. To O
sensor
2
M. To rear wheel sensor
N. To sub-wire harness
O. Install the terminal to touch the projection of the
crank case.
P. To starter motor
2-64
CABLE ROUTING