Yamaha 2009 Diversion XJ6S Service Manual page 434

Fault code No.
Symptom
Fail-safe action
Diagnostic monitoring
code No.
Meter display
Checking method
Order
1
2
3
4
30
Turnover of vehicle
Engine startup: Impossible
Riding: Impossible
08
The lean angle sensor value is indicated.
0 to 5.0 V
The vehicle is in a vertical position: 0.4–1.4 V
The vehicle is turned over: 3.7–4.4 V
Remove the lean angle sensor, tilt the vehicle more than 65 degrees, and
check the meter indication value.
Item/components and
probable cause
Turnover of vehicle
Sensor installation status Check for a loose mount-
Lean angle sensor mal-
function
ECU malfunction
FUEL INJECTION SYSTEM
Check or maintenance
job
Raise the vehicle to the
upright position.
ing, pinched mounting, or
hard mounting.
Make sure that the
mounting position is cor-
rect.
Diagnostic mode (Code
No. D08)
In vertical position:
0.4–1.4 V
When turned over:
3.7–4.4 V
Indication is incorrect. ⇒
Replace the lean angle
sensor. Refer to
"CHECKING THE LEAN
ANGLE SENSOR" on
.
page 8-162
Replace the ECU.
8-63
Sensor inspection
procedure
Place the main switch to
the ON position.
(however, the engine
cannot be restarted
unless the main switch is
first turned OFF)