Yamaha 2009 Diversion XJ6S Service Manual page 14

Odometer and tripmeter modes
1. Odometer/tripmeter/fuel reserve tripmeter
Push the "SELECT" button to switch the display
between the odometer mode "ODO" and the
tripmeter modes "TRIP A" and "TRIP B" in the
following order:
TRIP A → TRIP B → ODO → TRIP A
When the fuel amount in the fuel tank decreases
to 3.2 L (0.85 US gal, 0.70 Imp.gal), the left seg-
ment of the fuel meter will start flashing, and the
odometer display will automatically change to
the fuel reserve tripmeter mode "F-TRIP" and
start counting the distance traveled from that
point. In that case, push the "SELECT" button to
switch the display between the various tripmeter
and odometer modes in the following order:
F-TRIP → TRIP A → TRIP B → ODO → F-TRIP
To reset a tripmeter, select it by pushing the
"SELECT" button, and then push the "RESET"
button for at least one second. If you do not reset
the fuel reserve tripmeter manually, it will reset
itself automatically and the display will return to
the prior mode after refueling and traveling 5 km
(3 mi).
Fuel meter
1
1. Fuel meter
The fuel meter indicates the amount of fuel in the
fuel tank. The display segments of the fuel meter
disappear towards "E" (Empty) as the fuel level
decreases. When the last segment on the left
starts flashing, refuel as soon as possible.
TIP
This fuel meter is equipped with a self-diagnosis
1
1-5
system. If a problem is detected in the electrical
circuit, the following cycle is repeated until the
malfunction is corrected: fuel level segments
and symbol " " flash eight times, then go off for
approximately 3 seconds. If this occurs, check
the electrical circuit. Refer to "SIGNALING SYS-
TEM" on page 8-27.
Coolant temperature mode
1
1. Coolant temperature display
The coolant temperature display indicates the
temperature of the coolant.
ECA20S1007
NOTICE
Do not continue to operate the engine if it is
overheating.
Self-diagnosis device
1
1. Error code display
This model is equipped with a self-diagnosis de-
vice for various electrical circuits.
If a problem is detected in any of those circuits,
the engine trouble warning light will come on
and the display will indicate an error code.
The self-diagnosis device also detects problems
in the immobilizer system circuits.
If a problem is detected in the immobilizer sys-
tem circuits, the immobilizer system indicator
light will flash and the display will indicate an er-
ror code.
TIP
If the display indicates error code 52, this could
be caused by transponder interference. If this
error code appears, try the following.
FEATURES