Yamaha 2009 Diversion XJ6S Service Manual page 105

1. Fuel tank drain hose
2. Rear mudguard assembly
3. ECU lead
4. Starter motor lead
5. Oil level switch lead
6. Sidestand switch lead
7. Sub-wire harness (throttle body)
8. Throttle body joint connector
9. Wire harness
A. Clamp the wire harness and AC magneto lead.
Direct the end of clamp out and downward. No
need to cut off its end.
B. To fuel pump
C. Insert the wire harness clamp into the side cover
bracket.
D. To fuel tank
E. Insert the wire harness inside of the frame from
behind the battery.
F. Clamp the seat lock cable to the inside of frame in
this area.
G. Take care not pinch the wire harness between
battery and frame on the battery installation.
H. Clamp the sidestand switch lead and oil level
switch lead.
I. The leads may be crossed.
J. Pass the sidestand switch lead and oil level switch
lead inside the chain drive case cover.
K. Clamp the leads. Direct the end of clamp inside of
the vehicle.
2-60
CABLE ROUTING