Yamaha 2009 Diversion XJ6S Service Manual page 232

7. Install:
Clutch lever holder "1"
G
Clutch cable
G
Clutch lever holder bolt
11 Nm (1.1 m·kgf, 7.9 ft·lbf)
TIP
Align the slit on the clutch lever holder with the
punch mark "a" on the handlebar.
8. Install:
Left handlebar switch
G
TIP
Align the projection "a" on the left handlebar
switch with the hole "b" on the handlebar.
9. Install:
Handlebar grip
G
Grip end
G
Grip end
26 Nm (2.6 m·kgf, 19 ft·lbf)
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
a. Apply a thin coat of rubber adhesive onto the
b
b. Slide the handlebar grip over the left end of
c. Wipe off any excess rubber adhesive with a
EWA13700
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
10.Adjust:
11.Adjust:
4-60
left end of the handlebar.
the handlebar.
clean rag.
WARNING
Throttle cable free play
G
Refer to "ADJUSTING THE THROTTLE CA-
BLE FREE PLAY" on page 3-30.
Throttle cable free play
3.0–5.0 mm (0.12–0.20 in)
Clutch cable free play
G
Refer to "ADJUSTING THE CLUTCH CA-
BLE FREE PLAY" on page 3-11.
HANDLEBAR