EWM Phoenix 401 Progress puls MM FKW Operating Instructions Manual page 99

Table of Contents

Advertisement

The number of programs (P
1st cycle
Press and hold torch trigger.
Shielding gas is expelled (gas pre-flows).
Wire feed motor runs at "creep speed".
Arc ignites after the wire electrode makes contact with the workpiece, welding current is flowing (start
program P
START
2nd cycle
Release torch trigger.
Slope to main program P
The slope to main program P
latest when the torch trigger is released. Tapping (pressing briefly and releasing within 0.3 sec)
can switch to other programs. Programs P
3rd cycle
Press and hold torch trigger.
Slope to end program P
trigger longer than 0.3 sec. P
4th cycle
Release torch trigger.
WF motor stops.
Arc is extinguished after the pre-selected wire burn-back time elapses.
Gas post-flow time elapses.
Latched/special-latched tap start (P9)
In latched – tap start – operating mode it is possible to switch straight to the second step by tapping the
torch trigger; it is not necessary for current to be flowing.
The welding can be halted by pressing the torch trigger for a second time.
099-005323-EW501
21.05.2014
) corresponds to the cycle number specified under N cycle.
An
from P
)
A1
.
A1
is given at the earliest after the set time t
A1
from P
. The program can be stopped at any time by pressing the torch
END
AN
from P
END
AN
Special parameters (advanced settings)
to P
are possible.
A1
A9
is then executed.
Design and function
elapses and at the
START
99

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Phoenix 401 Progress puls MM FKW and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

This manual is also suitable for:

Phoenix 501 progress puls mm fkw

Table of Contents