Resetting Jobs (Welding Tasks) To The Factory Settings; Resetting A Single Job - EWM Phoenix 401 Progress puls MM FKW Operating Instructions Manual

7.3

Resetting JOBs (welding tasks) to the factory settings

7.3.1

Resetting a single JOB

All customised welding parameters that are stored will be replaced by the factory
settings.
Display
099-005323-EW501
21.05.2014
ENTER
3 s
JOB-
LIST
Setting/selection
Reset to factory settings
The RESET will be done after pressing the button.
The menu will be ended when no changes are done after 3 sec.
JOB-number (example)
The shown JOB will be set to ex works.
Resetting JOBs (welding tasks) to the factory settings
NOTE
RESET
Figure 7-1
Rectifying faults
3 s
JOB-
LIST
EXIT
3 s
113