Resetting Jobs (Welding Tasks) To The Factory Settings; Resetting A Single Job - EWM Phoenix 301 Progress puls Operating Instructions Manual

7.2

Resetting JOBs (welding tasks) to the factory settings

All customised welding parameters that are stored will be replaced by the factory
settings.
7.2.1

Resetting a single JOB

Display
099-005023-EW501
09.08.2010
JOB-
LIST
Setting/selection
Reset to factory settings
The RESET will be done after pressing the button.
The menu will be ended when no changes are done after 3 sec.
JOB-number (example)
The shown JOB will be set to ex works.
Resetting JOBs (welding tasks) to the factory settings
NOTE
m /m in
Figure 7-1
Rectifying faults
JOB-
LIST
95