Pads; Preferences: Lock - Korg Liverpool Owner's Manual

50 Style Play operating mode
Page 22 - Pads
W (Wrap Around)
The wrap-around point is the highest register limit for
the backing track. The accompaniment patterns will be
transposed according to the detected chord. If the
chord is too high, the Style tracks might play in a regis-
ter that is too high, and therefore unnatural. If, how-
ever, it reaches the wrap-around point, it will be
automatically transposed an octave lower.
The wrap-around point can be set for each track in
semitone steps up to a maximum of 12 semitones, rela-
tive to the chord root. This value will be the interval
between the key specified by the Style Element and the
wrap-around point.
1...12 Maximum transposition (in semitones) of
the track, referred to the original key of
the pattern.
KR (Keyboard Range)
This parameter is an on/off switch for the Key Range
parameter memorized into the Style.
Or(iginal) The Keyboard Range is used. When a
track goes over the lower or higher limit
set by this (hidden) parameter, it is trans-
posed, to play into the programmed
range.
Off No Keyboard Range used.
PAGE 22 - PADS
This page lets you select a different sound or function
for each of the four PAD buttons.
1–4
Each of the four PAD buttons. See "List of sounds
assignable to the Pads" on page 228 and "List of func-
tions assignable to the Pads" on page 229.
Note: Function names are preceded by an asterisk (*)
Volume
Volume for each of the four Pad tracks.
Pan
Pan for each of the four Pad tracks.
-64 Fully Left.
00 Centered.
+63 Fully Right.
C Send
Send level to the C Internal FX processor (usually
reverb) for each of the four Pad tracks.
D Send
Send level to the D Internal FX processor (usually mod-
ulating effect) for each of the four Pad tracks.
PAGE 23 - PREFERENCES: LOCK
You can "lock" various functions, to avoid they can be
changed when selecting a different Performance, Style
or Single Touch Setting.
Hint: When turning the instrument on, Performance 1 is
automatically selected. Therefore, if you wish your parame-
ters to stay unchanged, save your preferred default settings
into Performance 1 (see "The Write window" on page 42),
and turn these locks on.
Note: These settings are stored in the Global file. After
changing these settings, press WRITE to save them into the
Global. The Write Global window will appear (see "The
Write window" on page 126).

Pads

Sounds or functions assigned to the Pads.
Scale
When this lock function is On, the Scale parameter
does not change when selecting a different Perfor-
mance, Style or Single Touch Setting.
Auto Octave
This lock lets the instrument automatically transpose
the Upper tracks when switching between the FULL
UPPER and the SPLIT Keyboard modes.
On When switching to the FULL UPPER or
SPLIT Keyboard Mode, the Upper tracks
transposition is left unchanged.
Off When switching to the FULL UPPER Key-
board Mode, the Upper tracks Octave
Transpose is automatically set to "0".
When switching to the SPLIT Keyboard
Mode, the Upper tracks Octave Transpose
is automatically set to "-1".
M.Trnsp (Master Transpose)
The Master Transpose value is memorized into the Per-
formance or Style Performance. To prevent the Master
Transpose to be automatically changed when selecting
a Style or Performance, this lock should be set to On.
On (Default) The lock is engaged. When
selecting a Style or Performance, the Mas-
ter Transpose will not change.
Off The lock is turned off. When selecting a
Style or Performance, the Master Trans-
pose value may change, according to the
data memorized into the Performance or
Style Performance.