Korg Liverpool Owner's Manual page 61

very useful to record different percussive instru-
ments at any cycle on a Drum or Percussion track.
Note: While recording, the track's Keyboard Range
(see page 68) is ignored, and the track can play over the
whole keyboard range. The Local parameter (see
"Local" on page 128) is also automatically set to On, to
allow playing on the keyboard.
8. When finished recording, press START/STOP to
stop the arranger. Select a different track, and go
on recording the whole Chord Variation.
Note: You can select a different track only when the
arranger is not running.
9. When finished recording the Chord Variation,
select a different Chord Variation or Style Element
to go on recording the whole Style.
10. When finished recording the new Style, press
WRITE or RECORD to save it in memory. The
Write page will appear:
• To change the Style's name: press the right A
VOLUME/VALUE button to enter editing, and
modify the name using the UP/DOWN buttons to
move the cursor, and the DIAL to select a charac-
ter. Press INSERT to insert a character at the cursor
position, or DELETE to delete it.
• To select a different location in memory, press
one of the B VOLUME/VALUE buttons, then select
a location with these buttons or the TEMPO/
VALUE controls.
Press ENTER to confirm, or one of the D (Abort)
VOLUME/VALUE buttons to abort the save. The
"Are you sure?" message will appear in the display.
Press ENTER to confirm, EXIT to abort. After press-
ing ENTER, you will exit from the Record mode.
If you press EXIT while in the Write page, you will
go back to the previous Style Record page, without
any change.
Step Record procedure
1. When still in the Main page of the Style Record
mode, press one of the E VOLUME/VALUE but-
tons, to select the "R" parameter. Use these but-
tons, or the TEMPO/VALUE controls, to select the
"Stp" recording mode.
2. Press TRK SELECT to switch to the Style Tracks
page. Here you can assign the right Program to
each Style track. (For more details, see "Style
Tracks page" on page 56).
3. Assign a Program to each track, by using the PRO-
GRAM/PERFORMANCE section.
4. Press START/STOP to turn on its LED and enter
the Step Record page. (See "Step Record page" on
page 57 for more information on each parameter of
this page).
Previous event
(a)
(b)
Current position
Waiting for a keystroke...
The first two lines (a) are the latest inserted event.
The last two lines (b) are the event currently in
edit, ready to be inserted.
The "Empty" event marks the beginning of the pat-
tern, when there are no events inserted. It is auto-
matically inserted when entering the Record mode.
It will be removed when an event is inserted.
5. The "Maaa.bb.ccc" parameter in (b) is the current
position. This is the place where the note in edit
will be inserted.
• If you don't want to insert a note at this posi-
tion, insert a rest instead, as shown in step 7.
• To jump to the next measure, filling the remain-
ing beats with rests, press the >> button.
6. To change the step value, use the NOTE VALUE
buttons, on the lower left area of the control panel.
7. Insert a note, rest or chord at the current position.
• To insert a single note, just play it on the key-
board. The inserted note length will match the step
length. You may change the velocity and relative
duration of the note, by editing the V (Velocity)
and D (Duration) parameters. See "V (Velocity)"
and "D (Duration)" on page 57.
Style Record mode
Style Record procedure
Event to be inserted
Step value
59