Rear Panel - Korg Liverpool Owner's Manual

22

Rear panel

5. REAR PANEL
1
1 PHONES
Use this jack to connect a pair of headphones. You can
use headphones with an impedance of 16–200Ω (50Ω
suggested). Use a headphone distributor to connect
more than one pair of headphones.
2 INPUT
Use these unbalanced connectors to input another key-
board/synthesizer, a (non-powered) mixer's output, or
a CD/tape player (line impedance). The signal is auto-
matically routed to the speakers, the Audio Outputs
and the Phones.
3 OUTPUTS
Use these unbalanced connectors to send the audio sig-
nal (sound) to a mixer, a PA system, a set of powered
monitors, or your hi-fi system. Set the output level with
the MASTER VOLUME slider.
4 DAMPER
Use this to connect a Damper pedal, like the KORG
PS1, PS3 or DS1H. To change its polarity, see "Damper
Pol. (Damper Polarity)" on page 127.
5 ASSIGN. PDL/SW
Use this to connect a continuous or footswitch pedal,
like the KORG EXP2 or XVP10. To program it, see "P/S
(Pedal/Switch)" on page 127.
6 MIDI interface
The MIDI interface allows your Liverpool to be con-
nected to an external controller (master keyboard,
2 3 4 5 6 7 8
MIDI guitar, wind controller, MIDI accordion...), to an
expander, or to a computer running a sequencer or an
editor. For more information on how to use the MIDI
interface, see the MIDI chapter.
IN This connector receives MIDI data from a
computer or a controller. Connect it to an
external controller's or computer's MIDI
OUT.
OUT This connector sends MIDI data generated
by the Liverpool's keyboard, controllers,
and/or the internal sequencer. Connect it
to an expander's or computer's MIDI IN.
7 DC 12V (AC power adapter connector)
Plug the supplied power adapter into this connector.
8 SD Card Slot
To insert an SD card (or SDHC card),
push it into the slot until it clicks into
place. To remove the SD card, push it in;
the card will pop out slightly, allowing
you to pull it out.
Note: Carefully read the owner's manual
that came with your SD card, and observe
the instructions regarding care and han-
dling.
Note: Take care to insert the SD card in the correct direction
and orientation, and be sure to press it all the way into the
slot. Do not use excessive force.
Connector
side