Event Filter - Korg Liverpool Owner's Manual

64 Style Record mode
Page 5 - Event Filter
Length
Length of the selected Note event. The value format is
the same as the Position value.
Note: If you change a length of "000.00.000" to a different
value, you can't go back to the original value. This rather
uncommon zero-length value may be found in some drum or
percussion tracks.
Transport, navigation and editing controls
E/F and H VOLUME/VALUE buttons
These buttons are the "Scroll to previous event" (E/F)
and "Scroll to next event" (H) controls. They corre-
sponds to the scrolling arrows shown on the screen.
G VOLUME/VALUE buttons
Use these buttons to select the corresponding parame-
ter value area.
F-3 and F-4 buttons
After selecting the parameter value area with the G
VOLUME/VALUE buttons, use these buttons to select,
respectively, the first and second value of the event in
edit.
START/STOP button
Press START/STOP and play some chords on the key-
board to test the pattern in edit. Press START/STOP
again to stop the pattern running.
SHIFT + << or >>
Keep the SHIFT button pressed and press the << or >>
button to open the Go to Measure window.
Use the TEMPO/VALUE controls to select a measure,
then press ENTER to confirm, or EXIT to abort.
INSERT
Press the INSERT button to insert a new event at the
current shown Position. The default values are Type =
Note, Pitch = C4, Velocity = 100, Length = 192.
After inserting an event, use the C VOLUME/VALUE
buttons to select the Event line, and the same buttons
or the TEMPO/VALUE controls to select a different
event type.
DELETE
Press the DELETE button to delete the event shown in
the display.
PAGE 5 - EVENT FILTER
This page is where you can select the event types to be
shown in the Event Edit page. You can access this page
by pressing the PAGE+ button, while you are in the
Event Edit page.
Turn Off the filter for all event types you wish to see in
the Event Edit page.
Note: Some of the events are "ghosted", and non editable,
since the corresponding events are not editable in a Style.
Note Notes.
Ctrl Control Change events. Only the follow-
ing Control Change numbers are allowed.
Control function CC# (Control Change Number)
Modulation 1
Modulation 2
Pan
(a)
Expression
CC#12
CC#13
Damper
Filter Resonance
Low Pass Filter Cutoff
CC#80
CC#81
CC#82
(a) Expression events cannot be inserted at the starting Position
(001.01.000). An Expression value is already among the default "header"
parameters of the Style Element.
Bend Pitch Bend events.
1
2
10
11
12
13
64
71
74
80
81
82