Realtime Recording Page - Korg Liverpool Owner's Manual

1. If you are in Record mode (RECORD LED on),
stop the sequencer and press RECORD to go back
to the Backing Sequence Playback page.
2. Select the Save Song button. The Save Song page
appears.
3. Move the folder where you wish to save your Song
to the first line of the display, using the E–F (Scroll
Up) and G–H (Scroll Down) VOLUME/VALUE
buttons, or the TEMPO/VALUE controls. Press F-3
(OPEN) to open it. Close the current folder by
pressing F-4 (CLOSE).
4. When in the selected folder, you can save the Song
over an existing file, or create a new file.
• To overwrite an existing file, move it to the first
line of the display.
• To create a new file, move the "NEW_NAME.MID"
item to the first line of the display.
5. When the "NEW_NAME.MID" item is selected,
press one of the A VOLUME/VALUE buttons. You
are prompted to assign a name to the new folder:
Move the cursor using the DOWN/- and UP/+ but-
tons. Select a character using the DIAL. Insert a
character at the cursor position by pressing the
INSERT button. Delete a character at the cursor
position by pressing the DELETE button.
6. When you have finished writing a name for the
new midifile, press F-2 (SAVE) to confirm. The
"Are you sure?" message will appear. Press
ENTER to confirm, or EXIT to abort.

REALTIME RECORDING PAGE

While you are in Backing Sequence mode, press
RECORD, then one of the A VOLUME/VALUE but-
tons, to access the Realtime Recording mode. The
RECORD LED turns on.
Backing Sequence operating mode
Style
This non-editable parameter shows the selected Style.
If no Style is selected, the name will be empty. You can
select a different Style, using the STYLE section (see
"Selecting a Style" on page 26).
0...99%
This non-editable parameters shows the remaining
recording space in memory, as a percentage.
Perf or STS (Performance or STS)
This non-editable parameter shows the selected Perfor-
mance or STS (depending on the last item selected). If
no Performance or STS is selected, the name will be
empty. You can select a different Performance, using
the PROGRAM/PERFORMANCE section (see "Select-
ing a Performance" on page 25). To select one of the
four STS for the current Style, use the F-1–F-4 buttons.
Resol (Resolution)
Use this parameter to set the quantization during
recording. Quantization is a way of correcting timing
errors; notes played too soon or too later are moved to
the nearest axis of a rhythmic "grid", set with this
parameter, thus playing perfectly in time.
Hi No quantization applied.
(1/32)... (1/8)
Grid resolution, in musical values. For
example, when you select 1/8, all notes are
moved to the nearest 1/8 division. When
you select 1/4, all notes are moved to the
nearest 1/4 division.
Hi (no quan-
tization)
1/16
1/8
Sel.Tempo (Select Tempo)
Select this parameter to use the TEMPO/VALUE sec-
tion to select the Tempo. When you select this parame-
ter, the VALUE LED turns off.
Metro (Metronome)
This parameter sets the metronome mode during
recording.
Off The metronome can be heard only during
the precount.
On1 The metronome plays during recording.
Recording begins with a 1-bar precount.
Start recording after bar -1.
On2 The metronome plays during recording.
Recording begins with a 2-bar precount.
Start recording after bar -1.
RT/Pads
Ch/Acc
These parameters let you decide the track status during
recording.
Realtime Recording page
85