Table of Contents
Advertisement
PAGE 4 - MIXER: FX SEND A/B (OR C/D)
This page lets you set the level of the track's direct
(uneffected) signal going to the A and B, or C and D
Internal FX pair. Go to the previous page ("Page 3 -
Mixer: FX Block") to select an FX pair.
Use the TRACK SELECT button to switch from tracks
1–8 to tracks 9–16.
Here is the edit procedure:
1.
Use the VOLUME/VALUE (A–H) buttons to select
a track.
2.
Use the F-1–F-4 buttons to select a parameter for
that track.
3.
Use the TEMPO/VALUE controls to change the
parameter's value.
Parameters
000
No effect. Only the direct (uneffected) sig-
nal goes to the outputs.
127
100% effect. The direct (uneffected) and
effected signals go to the outputs with the
same level.
Page 4 - Mixer: FX Send A/B (or C/D)
PAGE 5 - TUNING: DETUNE
This page is where you can set the fine tuning for each
track.
Use the TRACK SELECT button to switch between
Song tracks 1–8, Song tracks 9–16, and back again.
Detune
This is the fine tuning.
-64
Lowest pitch.
0
Standard tuning.
+63
Highest pitch.
PAGE 6 - TUNING: SCALE
This page lets you program the alternative scale for the
Song tracks.
Scale
Alternative scale for the Song tracks. See "Scales" on
page 229 for a list of available scales. To enable/disable
the alternative scale for each Song track, see "Page 7 -
Tuning: PitchBend/Scale" on page 98.
Key
Parameter required for some Scales, when you should
set a preferred key.
Note
Note in edit, to be detuned. This parameter can be
accessed when a User Scale is selected.
Detune
Note detune, compared to the standard Equal tuning. This
parameter can be accessed when a User Scale is selected.
Song operating mode
97
Advertisement
Table of Contents
Troubleshooting
