Using Sets; Selecting Sets - Roland FR-3x Owner's Manual

Il
Using Sets
V- Acco rd io n
Roland
U sing Sets
The FR-3x is a "virtual" accordion. It recreates the sounds of various accordion instruments and can even generate
orehestrai sounds (like trumpet, flute, etc), organ and drum sounds.
Recalling a Set is silllilar to switching to a different
accordion.
Most of these set-
tings can be saved.
GLOBAL
Me tronome
Reverb
Chorus
Level
Touch
User S~t 4
Set 3
I
Set 2
Set 1
The FR -3x contains 25 Sets divided over 10 fal1l ilies. 9
Set fal1lilies have been progral1ll1led at the factory
("CLASS I C"~"ETH N I C",
see the legends above the treble
registers), while ane fal1lily ("USER") can be Llsed to load
User Sets frol1l an optional USB l1lel1lory.
Each Set fal1lily l1lay cOl1lprise severai Se ts (see "Factory
Se ts" on p. 69). Recalling aSet il1ll1lediately changes the
settings of the sections presented on p. 26 and config-
LIres the treble and bass registers.
Seleeting Sets
To se/ect the desired Set, proceed os follows:
1.
Press the
[SET]
register.
The nLll1lber of t he selected Set flashes in the display.
The firs t digit frol1l the left refers to the Set fal1lily,
the second to the Set l1lel1lory within that fal1lily. If,
after pressing (SET] once, YOLi do not press a treble
register, the display retLirns to the l1lain page after a
while.
In that case, press (SET] again and proceed with step
2.
[NOTE ]
If YOLi hold down [SET) for more than 2 seconds without
pressing another register, the FR-3 x switches to PARAME-
TER made. In that case, press [SET) again to leave that
made, then repeat step 1.
2.
Press one of the treble registers
[1]~[O]
to
select the Set family.
Set selection is handled in the following way:
• If the Set fal1lily YOLi select is the sal1le as the ane YOLi
have been LIsing sa far, the FR-3x selects the next Set
within that fal1lily.
Exa mpl e: Pressing (1] CLASSIC whi le the displa y
shows "11" selects Set memory "12" (still within the
"CLASSIC" family) .
To ga from Set "11" to Set "14", YOLi therefore need to
press register
(1]
three times after pressing (SET]
• If YOLi select a different Set family, the FR-3x
switches to the newly selected Set fal1lily and recalls
the last l1lemory YOLi selected wi thin that family.
[NOTE]
For the User Set memories. the display shows a "U" and the
nUl11ber of the selected User Set
(1 ~ 4).
There are four User
Sets.
[NOTE]
See the table on page 69 for the factory-programl11ed Sets.
[NOTE]
While the USER PRG indicator below the display lights. it is
impossible to select Sets.
2 5