Recalling A User Program; Editing A User Program - Roland FR-3x Owner's Manual

Recalling a User Program
Proceed as follows to recall a User Progra m yo u saved
earlier :
1.
Press the [USER PROGRAM] button.
The display now shows a "UP-" message.
Lights
The USE R PRG in dica tor below the display lights to
in di cate that the FR-3x is now in User Program mode.
2.
Press the treble register
([1]~[O])
that is
assigned to the User Program whose set-
tings you want to use.
The "-" to the right of "UP" changes to the number of
the selected User Program.
3.
Start playing with the new settings.
If necessary, yo u can selec t a different User Program
(see ste p 2 above).
4.
Press the [USER PROGRAM] button again to
leave this mode.
The USER PRG indica tor below the display goes dark
to indicate tha t the FR-3x is no longer in User Pro-
gram mode. At this point, the FR-3x returns to the
settings you were using before seleeting User Pro-
gram mode, and the display once again shows the
main page.
[NOTE]
While the US ER PROGRAM indica tor below the display
lights, it is impossible to selec t Sets.
V-Accordion
Roland
5aving your settings (User Program)
Editing a User Program
Yo u can also edit existing User Progra ms.
1.
Recall the User Program you want to edit.
See "R ecalling a User Program ".
2.
Press and hold the [USER PROGRAM] button
to select User Program Edit mode.
The USER PRG in dica tor fl ashes. The display shows
th e main page where the num bers of the selected
re gisters are displayed.
3.
Change the settings you want to correct.
4.
Press and hold the [USER PROGRAM] button
to enter write mode.
The display now shows a fl ashing "UPx" message (t he
"x" refers to the User Progra m yo u have been editing
thus far).
Flashes
5.
Do one of the following:
• To replace (overwrite) the settings of the User Pro-
gram you have been edi tin g, press the treble register
corresponding to its number.
• To save the new version to a different User Program
memory, press the assi gned treble register instead .
Your se ttings are sa ved to the selected User Program
memory.
6.
Press the [USER PROGRAM] button again to
leave this mode.
The US ER PRG indicator below the display goes dark
to indicate that the FR-3x is no longer· in User Pro-
gram mode. At this point, the FR-3x returns to the
settings you were using before selecting User Pro-
gram mode, and the display once again shows the
Illain page.
While the USER PRG illClicator below the display flashes,
YOll
can select another Sel.
3 9