The Machine Doesn't Run; The Printer Unit Doesn't Run; The Media Take-Up System Doesn't Run; The Media Heating System Doesn't Warm Up - Roland XC-540 User Manual

7-1 The Machine Doesn't Run

The Printer Unit Doesn't Run

Is the power switched on?
Switch on the printer's main power, then press the sub power
switch and make sure the sub power switch lights up.
Is illuminated?
Output is not performed when
Pull back the loading lever, close the front cover, and press
.
Is the front cover open?
Close the front cover.
Is the top menu displayed?
If the top menu isn't displayed, output doesn't start even
when data is sent from the computer. To go to the top menu,
press , then press
Is illuminated?
When lights up, operation is paused. To resume,
press .
Has ink run out?
When printing data is sent while the screen shown in the
1 2 3 4 5 6
7 8 9 10 11 12
sounds. At the same time, operation pauses. When the ink
cartridge is replaced with a new one, printing or cutting
starts.
P. 43, "If Ink Runs Out"
P. 91, "Determining What Happens When an Ink Car-
tridge Is Empty"
Is a message displayed on the screen?
P. 137, "If a Message Appears"
P. 138, "If an Error Message Appears"
Is the cable connected?
Connect the cable securely.
Is the network connection correct?
Check the network settings on the printer and the port set-
ting for the software RIP. In the software RIP, specify the IP
address assigned to the printer.
Make sure the network routing is suitable. Try connecting
the computer and the machine to the same hub, or con-
necting them directly using a crossover cable. If this makes
it possible to perform output, it means the problem is in the
network itself.
Make sure the green link LED of ethernet connecter is on. If
the light is dark, the network connection is not correct.
If output is impossible even though the link LED is on, make
sure the IP address and other settings are correct. The set-
130 Chapter 7 What to Do If
is not illuminated.
goes dark and printing resumes.
figure is displayed, a message
appears and a warning beep
tings on both the machine and the computer must be cor-
rect. Try making the settings again as you check for dupli-
cate IP addresses and typing errors.
Setup Guide
P. 118, "Viewing System Information"

The Media Take-up System Doesn't Run

Is the cable connected?
Connect the cable for the take-up unit to the machine. To
perform take-up automatically during printing, also make
the setting for the AUTO switch.
Setup Guide
P. 57, "How to Take Up Media"

The Media Heating System Doesn't Warm Up

Is media loaded?
The media heating system does not warm up to the preset
temperature when
dia, press , and wait for the machine to warm up.
P. 110, "Setting How the Media Heating System Oper-
ates"
Is the temperature of the room too low?
Use the machine in an environment where the temperature
is 20 to 32˚C (68 to 90˚F).
Link LED
is dark (by default). Load me-