Installer Setting - Scantronic 808 Installation And Programming Manual

Users can reprogram limited parts of the system. The 808 provides the
following set of user menus:
Menu 2
Menu 3
Menu 4
Menu 6
Menu 7
Menu 8
Menu 9
To gain access to these menus from a keypad the user must key in:
[Access Code] + [Menu key] + [Menu Number]
For more information on using the 808 see "808 User Guide".

Installer Setting

When you leave Programming Mode the system will allow you to enter the
Installer access code and use menus 4, 6, 7 and 9. In addition, you can also
set and unset the system by entering [0] + [Installer access code] + [Enter]
or [0] + [Installer access code] + [Level key].
The remote keypads display the message "System being configured" when
a Level has bee set using the Installer access code. Note that you cannot
use the Installer access code to unset the system when a user has set the
system with a user access code.
Omit 24 hour zones
System Options, Enable/Disable Chime.
Test Options, including Walk Test and Bell Test.
Set time and date
Change zone names
Change User Information (for example access
codes and authority levels). This Menu is available
to User 1 only.
Log Functions, including View Event Log and Print
Event Log
496234
4. Programming
45