To Store The Changes You Have Made; Entering Text - Scantronic 808 Installation And Programming Manual

4. Programming
12. Continue using the right and left arrow keys (C or D) to select attributes
and the up or down arrow keys (A or B) to enable or disable them. Note
that if you press the left arrow key (D) too often the display will move
back to showing the zone number and type only. Simply press the right
arrow key (C) until the display shows the attribute you want to change.

To store the changes you have made:

13. Press Enter.
The end station stores the changes you have made and
the display shows Menu 31 (Zone Name) for the next
zone (in this example zone 3)

Entering Text

Some menus have options that need you to enter text, for example zone
names. For those options the system lets you enter letters from the keypad
one at a time by pressing a number key repeatedly until the display shows
the letter you want. Each number key gives its own number and three letters
of the alphabet.
Figure 19 shows which letters belong to each number key. Select the letter
you want, press the key shown the correct number of times. Use the right
arrow key to move the cursor to the next space for a new letter.
If you make a mistake, use the left or right arrow keys to move the cursor
over the letter you want to change, and key in the new letter. If you want to
delete a name completely, use the left arrow key to move the cursor under
the extreme left hand character of the name. Press the left arrow key again.
The display clears the old name.
The system can store a maximum of eight characters per name, including
spaces and punctuation marks.
32 496234
ZONE 03 Z03-NAME