Initial Power Up; Power-Up With Mains - Scantronic 808 Installation And Programming Manual

Power-Up With Mains

Note: Depending on the status of the system when it is powered-up, e.g., open
tampers etc., some screens may differ from those shown below.
1. Apply battery power first, then connect the mains.
The keypad display shows the Software version number followed by
the date.
After 3 seconds, the display shows the time:
2. Key in the factory default user code (1234) and press Enter.
The display shows one of the following messages depending on how
the system is currently set up:
3. Key-in the factory default installer code zero (0) + 7890,
then press Menu.
The display shows:
4. Press 0.
The display shows:
5. Press Enter.
The display prompts you to remove the end station lid:
6. If the end station Tamper Switch is already open, close and open it
again.
You have now reached the Installer programming
mode. The display shows:

Initial Power Up

496234
3. Installation
16:07
SYS DIS RST REQ
MENU NO OR LEVEL
0:INST PROG
REMOVE LID
00-PROG SYSTEM
25