Using A 927 Fsl Zone - Scantronic 808 Installation And Programming Manual

3. Installation
2k2
Figure 10. Wiring Diagram for Multiple Alarm Contacts and Tamper Wiring.
Figure 11 shows the method for connecting foil, batten frames or lace wiring.
2k2
Figure 11. FSL Connections for Foil, Batten Frames or Lace Wiring.
Note: Always check resistor colour coding before wiring resistors into circuit. See
Figure 12 below.
Figure 12. Resistor Colour Code for FSL Resistors

Using a 927 FSL Zone

You can connect one FSL zone to a 927 Keypad (see Figure 8). Use the
terminals marked "FEZ" on the Arming Station connector. During program-
ming, the zone number of the device attached to the keypad depends on the
keypad number, as follows:
20
4k7
Door contacts
Note: When wiring FSL zones, link out the
anti-tamper terminals of each zone in use
on the main connnector and expander
cards.
4k7
Positive leg
Foil or CC wire
Negative leg
Foil or CC wire
Note: When wiring FSL zones, link out the
anti-tamper terminals of each zone in use
on the main connnector and expander
cards.
Yellow
Violet
4k7
Red
Gold
496234
Tamper loops
Red
Red
2k2
Red
Gold
Zone 1
CCT
Zone 1
AT
Zone 1
CCT
Zone 1
AT