Programming Reference; Factory Defaults; System Users; Installer Programming - Scantronic 808 Installation And Programming Manual

5. Programming Reference

Factory Defaults

When delivered from the factory, the 808 is preprogrammed with the follow-
ing default settings:

System Users

UO1: Access Code 1234, System Full Use, Zone omit Not Permit-
ted, Log Access = Permitted, Change Zone names = Permit-
ted, Change Data and Time = Permitted, Reset = Permitted
User 02-08: Not Used (Duress=Disabled)
User 00: Access Code = 7890

Installer programming

Menu 10: Account Name
Menu 11: Edit Name = No Name
Menu 20: Zone Type
Menu 21: Zone circuit type = CC
Menu 30: Program zones
Menu 31: Zone Names = ZO1: Zone 01 (all other zones to Zone [nnn])
Menu 32: Zone Types = All zones Not Used (NU)
Menu 40: Program multiflex
Menu 41: Level Allocation = Level A,B,C,D = None
Menu 42: Level Exit Mode = All Levels = Timed and terminate (Exit
Time = 10 Seconds)
Menu 43: Level Entry Time = All Levels 20 Seconds
Menu 44: Level Flexi-Zones = Not Set Up = NU
Menu 45: Level Alarm response = All Levels = Full Alarm
Menu 46: Level Re-Arms response = All Levels = Never
Menu 47: Keypad allocation = None
Menu 50: Program outputs
Menu 51: Output Types = Bell = Normally On, Strobe = Normally Off,
All other NO Function
Menu 52: Internal sounder = Follows Bell
Menu 53: Bell Delay = 0, Bell Time = 20 Minutes
Menu 60: Program System Options
Menu 61: Installer information = Code = 7890
Menu 62: PA response = Audible
Menu 63: Line Fault response = Audible
Menu 64: Allow Zone omits = Disabled
Menu 65: System reset = Customer
Menu 66: Logging Printer = Disabled
46 496234