Printer Options (Menu 09); Using The Test Zone Attribute - Scantronic 808 Installation And Programming Manual

6. Testing

Printer Options (Menu 09)

This menu allows you to print details on an attached printer.
1. Select Menu 00 and press down arrow until the display shows
"09:PRINT OPTIONS".
2. Press Enter.
The display shows:
3. Use the left or right arrow keys to display one of the following:
PRT CFG ALL (Print all configuration data)
PRT CFG KPD DAT (Print keypad data)
PRT CFG AREA DAT (Print area data)
PRT CFG LEVEL DA (Print level data)
PRT CFG ZONE DAT (Print zone data)
PRT CFG OPUT DAT (Print output data)
PRT CFG SYS DAT (Print system data)
PRINT EVENT LOG
3. Press Enter
The attached printer prints the selected report.

Using the Test Zone Attribute

You may decide that a particular zone is misbehaving, but the tests available
do not show anything amiss. The Test zone attribute lets you program the
system to monitor a suspect zone for a period of 14 days. During that time
the system will not raise an alarm if the zone is violated while the system is
set. However, the system will log the event on any attached printer, and also
show on the keypad display the message "CALL ENGINEER" followed by
"SOAKFAIL" . Note that if the zone is not violated during the 14 day period
then the system removes the Test zone attribute.
To set the Test attribute use Menu 32 to make the suspect zone a Normal
Alarm, and set the Test zone attribute to 'Y' (enabled).
62 496234
PRINT EVNT LOG