Example 1: Full Set And Three Part Sets - Scantronic 808 Installation And Programming Manual

4. Programming

Example 1: Full Set and Three Part Sets

This subsection shows how to program the 808 as an alarm system with a
full set Level, and three part set Levels. The diagram below shows an
example site where this type of system may be used.
Z7
Garage
Ground Floor
Area 4
First Floor
The end station and main keypad are fitted under the stairs on the ground
floor (Area 1). The main keypad is programmed as keypad number 1.
Bedroom 1 is fitted with a second 927 keypad, to which is attached a PIR on
the landing. The bedroom keypad is programmed as keypad number 2. The
system assigns the attached landing PIR to zone 10 (see "3 Installation -
Using a 927 FSL Zone").
Figures 21 and 22 show the sequence of Menus to use to program the
system for the example.
Use Menu 31 to give each zone an eight character name. If a detector
activates an alarm, the system reports the zone name on the display when a
36
Area 3
Z5
Kitchen
Dining
Office
Room
Z8 Z6
Bathroom
Bedroom 3
Bedroom 4
Figure 20. Site Plan for Example 1
496234
Z4
Living Room
Z2
Hall
Z3
Z1
Z10
Bedroom 2
Bedroom 1
Arming Station
Area 1
Area 2