Fitting The End Station - Scantronic 808 Installation And Programming Manual

3. Installation
1. Remove the screws from the end station cover and lift the cover off.
Figure 3 shows the inside of the end station.
20 mm
Cable Entries
Trunking knockout
2. Note the positions of the cable entries as follows:
a) Two plastic knock-outs top and bottom for trunking.
b) One 15mm bottom knock-out for alloy tubing.
c) Two 20mm knock-outs top and bottom.
d) Four 20mm circuit and sounder cable entries in the rear casing
adjacent to the main PCB.
e) One 20mm entry adjacent to the mains fuse terminal in the rear
casing for mains power only.
Warning
Do not feed mains cables and low voltage circuit
and sounder cables through the same entry.
Always keep separate.
12

Fitting the End Station

Lid Tamper Switch
Figure 3. End Station Internal Layout
496234
Transformer
Mains Fused terminal
(Euro 20mm type)
Space for a 6.5Ah battery