Table of Contents
Advertisement
All the Homelink options are part of the PROGRAM command. The following
instructions tell you how to issue that command so that you are then ready to
program an individual option.
To Set Homelink Options.
1.
Start the Homelink program.
The display shows:
2.
Press EXE.
The display shows:
3.
At this point you can:
•
Set the account number for the first of the four telephone
numbers.
•
Use the down arrow key to select one of the other telephone
numbers.
•
Use the down arrow key again to select the general options.
4.
When changing the details of the option you may have to use the left
and right arrow keys to select one of several alternatives, or you may
have to press EXE and enter some numbers.
5.
Press ON/CLEAR when you have finished making changes.
The PSION stores your changes and shows the main command list
again.
Note:
•
If you are keying in strings of digits and make a mistake you can use DEL to
erase any entries.
•
If you want to change part of the Homelink options without going through all
the stages, you can press ON/CLEAR at any point to take you back to the main
command list.
•
To step backwards through the program press the up arrow key.
The instructions for each option assume that you know how to start the
HLEXTRA program and execute the PROGRAM command.
Account Number
Homelink can store up to four eight-digit account numbers. Each account
number is associated with one of four telephone numbers. This means that
the unit can communicate with up to four independent monitoring services.
1.
Start the HLEXTRA program and execute the PROGRAM command.
The display shows:
Note: If you want to change the account number for another telephone number,
press the down arrow key until the display shows the destination you want.
Page 14
4. Setting Homelink Options
496759
PROGRAM DEFAULTS
TX RX OFF QUIT
ACCOUNT NO. 1
ACCOUNT NO. 1
Advertisement
Table of Contents
