Installer Setting - Scantronic 8136UK-50 Installation And User Manual

8136
Users can reprogram limited parts of the system. The 8136 provides the
following set of user menus:
Menu 1:
Menu 2:
Menu 3:
Menu 4:
Menu 5:
Menu 6:
Menu 7:
Menu 8:
Menu 9:
To gain access to these menus from a keypad the user must key in:
[Access Code] + [Menu key] + [Menu Number] + [Enter]
See pages 42 and 43 for more details on user menus.

Installer Setting

When you leave Programming Mode the system will allow you to enter the
Installer access code and use menus 4, 5, 6, 7 and 9. In addition, you can
also set and unset the system by entering either:
[0] + [Installer access code] + [Enter].
or:
[0] + [Installer access code] + [Level key] + [Enter].
When a Level has been set using the Installer access code, the remote
keypads show the message "System being configured". Note that you cannot
use the Installer access code to unset the system when a user has set the
system with a user access code.
Setting with omissions.
Omit 24 hour zones.
System Options, including Enable/Disable Chime,
adjust the internal sounder volume, and Enable/
Disable Remote Set/Unset from a PC.
Test Options, including Walk Test and Bell Test.
Uploading/Downloading Authority. (Answer remote
call from Central Station, and Call Out to a remote
PC.)
Set time and date.
Change Area and zone names.
Change User Information (for example access
codes and authority levels).
Log Functions, including View Event Log and Print
Event Log.
496339 Issue 4
Installer Setting
41 of 44