Advertisement
four digit user
code
ZONE NUMBER
Enter by
designated
route
2
TO FULL SET
Key in your user code and press
the 525r remote setting device). The exit tone starts.
Leave the premises by the designated exit route.
The exit tone stops after a preset time. The alarm
system is then set.
TO PART SET
To set your alarm system so that you can move
around part of the area normally covered by
detectors:
Key in your user code and press
lights all the zones that will work in part set. Key in
the numbers of the zones you want to switch on or
off. Press
when you have finished. The exit tone
starts. Leave the protected area. The tone stops
after a preset time. The system is then set.
The panel remembers the zones you selected for
part set. The next time you want to part set, enter
your user code, press
sets after sounding the exit tone.
(If you have a 525r remote setting device, press
The panel part sets in 3 seconds.)
Note: The installer may have disabled the part set
facility. Contact them if you have any difficulty.
IF THE SYSTEM WILL NOT SET
If you are setting or part setting the system, but the
panel gives an interrupted tone and zone lights are
on, then one or more detectors are being triggered.
Check that doors and windows are closed and there
is no movement in areas covered by movement
detectors.
Try to set the system again. If the fault persists call
the installer.
TO SWITCH OFF
Enter by the designated entry route. The entry tone
Go to
panel
starts. Go to the control panel and key in your four
digit user code (or press
setting device). The system switches off.
Why is the panel beeping? If the panel starts
"beeping" once a second after you have switched off
using your remote setting device then there has
been an alarm while you were out. The lights on the
panel indicate the cause of the alarm. Press
silence the tone.
496307 Issue 1
(or press
on
. The panel
and then
. The system
on your 525r remote
to
.
Advertisement
